Alan had a "FIELD REPAIR" Seminar and at the same time we had a "GULF COAST ROVERS" Booth !
|
Seminars & Booths were held for 2 days. |
Starting "How to break down the bead using the Hi-Lift. |
 |
 |
| Also how to use a tire plug tool. | And then reseat the tire" using a CO2 tank on the field. |
 |
 |
| I made sure to keep the tire away from the audience while re-seating. | |
 |
|
| We completely removed the front CV to show how along with replacing wheel bearings and brake pads & rotors. | Using the proper tools and factory shop manual procedures we proved it is not as complicated as people think. |
 |
 |
| Also showed damaged &removed components
like: A complete 3rd member Broken motor mounts Rear trailing arms Broken front & rear axles (including CV's) Front track rods Dented axle / diff housing A brief description of how to repair on the field was explained. |
Topics under the hood included: How to remove the fan. Deep water fording and how to make the rover drivable. Where the inertia switch is and what it does. Along with tips on a vehicle roll over and what is necessary to make it drivable. |
 |
 |
| Other seminar Jesse Rodocker - Vehicle Preparation |
Other seminar Rob Dassler- Coiler Mechanical |
 |
 |
| Premier Power welder had their RV along with test stand for people to try the welder on. | Tuffy was displaying the latest products. |
 |
 |
| ARB was also showing the new Series II products. | Rovers Accessories also attended. |
 |
 |
| Matt with RockWare too. | Rachel on the right selling the raffle tickets |
 |
 |